Make Shaker Cabinet Doors Ideas

0

Make shaker cabinet doors are the focus of kitchen cabinets and can supplement or remove from the overall aesthetics in the kitchen. More and more homeowners use cabinets with overlay doors because of their image-frame appearance. Whether they are elevated panel glass slab or shaker doors, the frame appearance cabinet causes the appearance of more architectural sound. The door you are going to do here is for a regular 30-inch-by-27-inch kitchen wall cabinet. Remember to make the doors one inch bigger in both width and height of the doorway.

Instructions

Set the fence on the DIY cabinet doors with glass saw two inches. Rip two pieces from each of one-of-6-by-30-inch timber. Set the fence on the table looked at 3/16 inch. Lower the blade to half an inch. Cut a score in the long sides of the four parts. Then, turn them to cut a groove on the same edge from the other side of the wood. This will result in a 3/8-inch-by-1/2-inch slot. Measure from the end of two of the 30-inch pieces and make a mark of 20 inches. Cut these with electric saw saws. Set the height of the blade to 3/16 inches. Cut 20-inch pieces over the grain on both sides and both ends.

Set the fence on the shaker cabinet doors saw 3/16 inches above the blade. Lift the blade up to half inch. Stand 20-inch pieces on their ends and cut both sides at both ends of each part. This will result in a “heavy” sliding into the track in 30-inch pieces. Set the fence on the table looked at 24½ inches. Cut ¼ inch plywood to this measurement. Then set the fence on the table looked at 21 inches and rip 24½-inch piece to this width. Mount the frame and ¼ inch panel to make sure they fit. Make any adjustments as needed.

Glue to one of the tongues on the rails and insert them into one of the ends. Then the shaker slides the panel into the grooves and applies glue on exposed tongues and installs the remaining end piece. Squeeze the door frame together with bar clamps over the rail. Keep a hot iron handy to rub over all areas that appear to bubble. Rub the iron over bubble area for five to ten seconds. This will activate cement. Roll back over the place or use a well-sanded wooden block to squeeze veneers properly. Trim the tabs by pressing the blade off a matt knife or sharp stiff iron down through the tabs against the edge of the cabinet door. Remove excess glue with thinner and sand edge even hand.

Share.

Comments are closed.