Instructions for Building a Dresser

0

Building a dresser with basic joinery skills and the right tools, you will be able to build or replace your own boxes. You can make your own custom kitchen cabinets at a fraction of the cost of buying them, with the addition of a personal, creative accent piece to the bedroom. Contemporary furniture makers know that complicated joints are not necessary on boxes; they are usually for aesthetics. The simple dumb joint in combination with modern glue and braces provide all the privacy you’ll ever need.

Instructions

Measure the width and depth of the box. When measurements, consider box slide slides. There are a wide range of box slide slides available on the market, so you may want to buy and install the glasses for how to build a tall dresser before you build the boxes. Cut the sides, front and back of the drawers from wood. Use the measurements from step one to measure and cut your two sides, front and back of the box. First, cut the tool to the desired height on your box. Then cut out the length to ensure that all four sides will be uniform in height.

Fold the joints to make a sturdy fit for drawer corners. Next, take your router and set its depth to about three-quarters of the width of your wood. Then, the router runs along the left side and right side of both the face and back of your back. Assemble the pieces. For the bottom of the simple dresser plans, you have a choice of either routing out a line thickness at the bottom so it slides in during installation, or you can install it directly to the bottom. Then nail or screw your drawers together. Place the trunk on all joints and use clips to keep them in place so that they are solid.

Install the bottom in slits routing around the box. After cutting the height of the box, measure from the bottom about half to three fourth inches and draw a line along the entire board. Thereafter, a slit half the depth of the wood and the thickness of the bottom out; Do this before cutting the pages to the desired length. If you install directly to the bottom, turn the box over so you look at the bottom of it. Use the router; adjust it so that you will route out half the thickness of the wood around the inside of the box. Finally, glue and nail the bottom of the tray.

Share.

Comments are closed.